International Interprotect 2.5 Litre
Processing...
new

International Interprotect 2.5 Litre

£105.99 £84.45
You save: £21.54  (20.32%)

plypa400-a2-5x

Qty


Marine Miles:

Marinestore miles reward your loyalty with future discounts at the checkout. 200 miles earned equal a £1 reward discount. T&C’s apply - click here

This item is worth 420 Marine Miles points!

  • Details

Description

Interprotect is a quick drying, easy to apply two-pack epoxy primer for high performance protection on all rigid substrates. It's two-component application gives excellent anti-corrosive and abrasion resistance properties and it can be used equally above or below the waterline. Not suitable for use below 5DegC. For detailed product information refer to www.yachtpaint.com.

Application Details: - Interprotect

  • Area: Above and below the waterline
  • Finish/Sheen: Matt
  • Thinner/ Cleaner: YTA061 Thinners No.7
  • Number of Coats: 1-5 by brush or roller depending on the substrate and use.
  • Method of application: Brush, Roller.
Drying/Overcoating Information:
Temperature
DegC
Pot
Life
Touch
Dry
Overcoating Time
(Self)
Overcoating Time
(Antifoul)
Immersion
Time
Min Max Min Max Min Max
5DegC 10 hrs 4 hrs 10 hrs 6 mnth 10 hrs 24 hrs 24 hrs -
15DegC 5 hrs 2 hrs 5 hrs 6 mnth 5 hrs 9 hrs 18 hrs -
23DegC 3 hrs 1 hr 3 hrs 6 mnth 3 hrs 7 hrs 12 hrs -
35DegC 2 hrs 30 min 2 hrs 6 mnth 1 hr 5 hrs 8 hrs -
Preparation:

WOOD: Sand with 80-280 grade paper depending
on the smoothness required.
Remove oil from oily woods like teak
using thinners no.9.
Change rag frequently.

LEAD: Rub down with an emery cloth
or power wire brush. Degrease
with Yacht Line Super Cleaner.
Pre-prime with Etch Primer.

STEEL: Grit blast to Sa 2.5 to 3.
An angle grinder can be used in small areas.
ALUMINIUM:
Above Waterline:
Clean and degrease
Pre-prime with Etch Primer.
Alternatively mechanically abrade
with aluminium compatible sandpaper
or low pressure grit blast using
aluminium oxide.

Below Waterline:
Degrease AND
abrade or grit blast as above.
ZINC/
GALVANISED STEEL:
Degrease. Pre-prime with Etch Primer

  1. If any filling required use the appropriate product from the Interfill range, after the first coat of Interprotect has been applied.
  2. Ensure all dust is removed with a dust wipe before painting.
  3. Stir individual components thoroughly, add curing agent to the base, stir and leave for 10 minutes for bubbles to disperse.
  4. Apply the following number of coats:- Steel/ Aluminium/ Alloy - above 4, below 5, Lead - 5, Wood - 3.
  • Stir well before use.
  • Mix ratio is 3:1 (base : curing agent) by volume (as supplied).
  • For Max performance, temperature should be above 10DegC.
  • If Max overcoating time is exceeded, abrade thoroughly using 180-220 grade paper.
  • Ideally should be applied to bare substrate, but do not apply over conventional (one-pack) coatings.

Product Reviews

No Reviews Yet!