Description
The Rule LoPro Bilge Pump is a low profile 5.6cm high and features a fully rotatable discharge body. The LP900S is designed for efficient and powerful pumping of the bilge in tight spaces. This model comes with two automatic modes, when the water level reaches 3.25cm or 5cm (the user can select their own threshold), the automatic pump kicks in. The high or low water sensing mode can be adjusted by turning the motor cartridge upside down. The other automatic mode operates by briefly turning the pump on every 2.5 minutes to check for water. The electronic automatic timed mode stays on once water is detected until the water is gone. This model also features a fail safe back up. All bilge switches and pumps can become covered or affected by oil, grease or debris, however the LP900S knows when this has occurred by checking for water resistance against the impeller. If no water is found to be present the pump switches to the electronic automatic timed mode until the sensor has been cleaned.
The entire body of the bilge pump can be swivelled up to 180 degrees, this makes the pump incredibly easy to install allowing it to be adjusted to fit into most areas. Adding to this, the unit features an array of mounting positions allowing it to easily accommodate to the boats design. There are also multiple ports available to fit this bilge pump; 19mm straight, 19mm right angle, 25mm and 28mm. The LP900S also features new tricuspid check valves to prevent any backflow within the pump.
The entire body of the bilge pump can be swivelled up to 180 degrees, this makes the pump incredibly easy to install allowing it to be adjusted to fit into most areas. Adding to this, the unit features an array of mounting positions allowing it to easily accommodate to the boats design. There are also multiple ports available to fit this bilge pump; 19mm straight, 19mm right angle, 25mm and 28mm. The LP900S also features new tricuspid check valves to prevent any backflow within the pump.
- Voltage: 12VDC>
- Flow: 900GPH open flow at 13.6V>
- Amp Draw: 4A approx
- Port Configuration: 3/4 inch, 1 inch, 1-1/8" Straight,>
- 90 degree 3/4"
- Backflow preventer valve can be used with straight fittings
- Height: 2.3"
- Length: 9.3"
- Width: as little as 2.3"